Adsorption of Congo Red dye (CR) on bituminous coal-based mesoporous activated carbon (AC)coal pellet active carbon from aqueous solutions was studied. The ACs used differed significantly in terms of total surface area, pore volume distribution and surface charge properties. The mesopore contribution to the total pore volume ranged from 52 to 83%. The adsorption tests were performed under static conditions at solution pH 7.8–8.3. The pH at the point of zero charge (pHPZC) for ACs used was over 10. It was found that the higher the fraction of mesopores with a size between 10 and 50 nm, the shorter the time to achieve the equilibrium stage for CR adsorption. The kinetics of adsorption in view of three kinetic models, i.e. the first-order Lagergren model, the pseudo-second-order model and the intraparticle diffusion model, was discussed. The pseudo-second-order kinetic model describes the adsorption of CR on mesoporous activated carbon very well. The correlation coefficients ranged from 0.980 to 0.991. The intraparticle diffusion into small mesopores was found to be the rate-limiting step in the adsorption process. The equilibrium adsorption data were interpreted using Langmuir and Freundlich models. The adsorption of CR was better represented by the Langmuir equation. The monolayer adsorption capacity of ACs was found to increase with increasing both the mesopore volume and the mesopore contribution to their porous texture. The effect of solution ionic strength on the uptake of CR by two different mesoporous carbons was also investigated.wood carbon powder